Tips

How to Pair Your Suunto Comfort Belt with Your Suunto T3: A Step-by-Step Guide

August 26, 2009 Freddy Reyes

Learn how to pair your Suunto T3 HR Belt with a new Suunto Comfort Belt in no time with this helpful guide from "The Heart Rate Monitor Shop".

How to Pair Your Suunto Comfort Belt with Your Suunto T3: A Step-by-Step Guide

I got a brand new Suunto Comfort Belt (ss013588000) to replace my old Suunto T3 HR Belt and I was having problems pairing the new strap belt. After some research on the internet I found the following article from “The Heart Rate Monitor Shop” that solve my problem. I was able to pair the HR Belt and my Suunto T3 in no time.

Here is the link:  http://tinyurl.com/b4gjh7

This is a quote from “The Heart Rate Monitor Shop“:

“Pairing HR BELT Suunto T3 – Suunto T4 – or newer “C” versions – same procedure applies.

Enter Training mode menu by long pressing the Enter button while in Training mode.

Step 1: Remove the battery from the transmitter belt.

Step 2: Short-circuit the – and + metal plates in the battery compartment by putting the battery in UPSIDE down for 4 – 5 seconds.. just hold it there – NOW pop it out…

Step 3: Select PAIR A POD in the TRAINING MENU of your Suunto t4/t3.

Step 4: Select PAIR HR BELT.  The message “TURN ON HR BELT” is displayed.

Step 5: Push the battery back in, the right way around (don’t worry about the hatch) – and at the same time rub the contact areas of the HR belt with both of your hands.  Your hands should be moist.

Step 6: One of the following messages will display within 30 seconds:

“HR BELT FOUND” – go to step 7/E

or, if pairing FAILED -  the unit returns to display “pair a pod” follow steps A-E below

Step A: If pairing failed and no devices were found, remove the battery from the transmitter belt.
Short-circuit the  – and + metal plates in the battery compartment by connecting them
with a metal instrument.  Or, the battery can be inserted upside-down into the compartment
and then removed.

Step B :  Select PAIR A POD in the TRAINING MENU of your Suunto t4/t3.

Step C: Select PAIR HR BELT.  The message “TURN ON HR BELT” will be displayed.

Step D: Insert the battery into the battery compartment and wait for the acknowledgment “HR BELT FOUND“.

Step 7/E: After pairing, put battery hatch back in place, careful not to pinch to rubber O’ring seal. You should now test the transmitter belt to make sure it is sending a signal. Make sure watch is in HR mode and not TE (Training Effect) mode (pressing and holding bottom left toggles between TE and HR).”

Ask Freddy

Explore my experience, projects, and articles.

Welcome

What would you like to explore? Choose a question below or ask your own.